Logo image
Back
Finite element based simulation of tribocorrosion at the head-neck junction of hip implants
Journal article   Peer reviewed

Finite element based simulation of tribocorrosion at the head-neck junction of hip implants

Khosro Fallahnezhad, Mohsen Feyzi, Khashayar Ghadirinejad, Reza Hashemi and Mark Taylor
Tribology international, Vol.165, pp.1-12
01/2022
DOI: https://doi.org/10.1016/j.triboint.2021.107284

Metrics

24 Record Views
26 Times Cited - Web of Science

UN Sustainable Development Goals (SDGs)

This output has contributed to the advancement of the following goals:

#3 Good Health and Well-Being

Source: InCites

Abstract

tribocorrosion finite element modelling taperosis hip implants
This study proposes a new finite element (FE) model for tribocorrosion at the head-neck junction of hip implants (known as taperosis). The model addresses the synergy in tribocorrosion to separate the role played by both the mechanical and chemical mechanisms. This algorithm was conceptualised for a ball-on-disk configuration; and it was then implemented on a distal fitting taper junction. Contact parameters and wear depths (both mechanical and chemical) were obtained as a result of level gait loading. The results demonstrate a linear pattern for the wear depths versus the number of loading cycles. The chemical wear spread over a larger area of the taper compared to the narrow region for the mechanical and total wear. Chemical reactions (corrosion) were responsible for 32% of the material loss; and this challenges the widely accepted assumption of neglecting the chemical wear in taperosis. The FE-predicted wear patterns were comparable with those observed in a number of retrieved tapers.

Details

Logo image